Product Specifications
- 43 ft. work height
- Full 360º continuous rotation
- Full 360º non-zone rated work area
- 5500 lb. Lifting capacity
- Meets or exceeds ANSI A92.2-2001, A10.31-2006, and SAE requirements
- Meets 46kv Category C dielectric qualifications
- Complete test documentation provided upon request
- Pin on a bucket with 300 lb.Cap. 45. ft working height (optional)
Product Features
- 5500 lb. lifting capacity with overload protection
- 3000 lb. transport capacity
- 5000 ft-lbs Auger torque with 2.5″ hex Kelly bar
- Insulated to 46 KV category C
- ANSI A10.31 compliant
- Full continuous rotation and 360º work zone
- Auger stored on side of boom
- 43 ft. sheave height
- Lower tool circuit with reel
- Very light ground footprint at 4psi
- Ability to travel 30º slopes and 20º side to side
- Fully proportional remote control
- Positive +80º boom elevation to -10º boom elevation
- Ability to carry pole to jobe site
- Hydraulic Pole Guide
- Bed space for carrying transformers to the job site
Other Features
- Pin on bucket with 300 lb. (135kg) capacity – 44 ft. (13.4M) working height
- Crawler tracks – Rubber 12′ (30 cm) wide, five idler wheels on each side.
- Crawler Drive Motors – Integrated orbit hydraulic motor with single-stage planetary drive gear.
- Transport Bed – 47″L x 35.5″W (124cm L x 90cm W), Capacity: 3000 lbs. (1135kg)
- Controls: Wireless Radio Remote
- Main Boom: 80 degrees about to -10 degree below horizontal hydraulic boom elevation
- Extensions: Three hydraulically operated steel sections and one manually extended fiberglass section with a hydraulic pole guide.
- Winch line, equipped with 9/16″ 100ft. (12m) polyester ropes.
- Auger: stored on side of boom with latching mechanism for transport
- Auger Drive: Sealed planetary gear reduction – 3500 ft. /lbs. (3745 N-M) torque. (5000 ft./lbs. optional)
- Auger Bit: 18″ (46 cm) diameter standard with 2″ hex output shaft. (2.5″ optional)
